How To Reset Your Rochester Home System
An important advantage of having your home security hooked up by trained experts is that you seldom need to make major adjustments to it. However, there will likely be a few instances where you must reset your alarms in Rochester. If you use the ADT Command interface, resetting usually needs only a few minor tap of a button following occurrences like battery changes, power outages, and false alarms.
Read The Owner’s Manual Before Attempting An Alarm Reset
A word to the wise before you try to reset your Rochester home security system, check your instruction manual prior to proceeding. You’ll never want to undermine your home’s protection due to pressing something incorrectly. Additionally, the process may have changed if you switched from a numerical keypad to a fully digital system. Keep in mind that if you’re unable to figure out how to reset your system, don't hesitate to reach out to your trusted security specialists.
Resetting Your Rochester Security System Due To A False Alarm
Usually, a false alarm takes place because of a sensor that was tripped by accident. You are able to use the ADT Command touchscreen or bring up the ADT mobile app and touch the shield image and type in your unique passcode to turn off the system when this occurs. You may receive notification from your 24-hour monitoring specialists, but simply inform them that you experienced a false alarm.
Tips To Reset Your Alarm After A Power Outage In Rochester
When you lose power due to high winds or other factors, you could start hearing a steady beep from your alarm’s central interface. This lets you know that your security is using the backup battery. To reset the alarm and stop the beeping, you should disarm/rearm the system.
Keep in mind, if your power outage lasts for prolonged time frame, you could need a total reset of your home’s security. Pay careful attention to the directions in the manual -- typically by entering your unique passcode and hitting the designated button two times -- and you should be back in business. You may still hear chirps from the backup power, as it might not cease until your battery is fully charged. Reach out to your security technician if you keep having problems with your ADT controls 20 hours after the power is resumed.
Reset Your Home Security System After Replacing A Battery
Occasionally you need to switch out a battery powering one of the devices in your security installation. When this needs to be done, you want to switch your system to Test Mode so you prevent setting off an accidental alarm. When the battery is replaced, remove the system from test mode and resume your usual settings. If the command center doesn't register the piece of equipment or the battery indicator remains on, you might need a whole system reset.
Tips to Reset Your Rochester Security System After Adding Or Deleting A User
Adding and deleting users can be done on your ADT Command interface and your ADT mobile app. You shouldn't need a reset of your alarm following the addition or deletion of users. But you should note, if you move into a new property that already has an ADT security system, you should reach out to your residential security experts at (585) 310-4555 to start a new service. The technician will come out and switch out outdated parts, install more alarms or cameras (if needed), and do a factory reset.
A Well-Designed Security System Can Be Yours Today
Figuring out how to reset a home security system in Rochester can be difficult if it isn’t equipped with user-friendly equipment and instructions. If the time has come to get your easy-to-use home protection system, call (585) 310-4555 or complete the form below. Our specialists are pleased to customize the ideal security system for your needs.